HCM（YMX）
VFD1A5MH43ANSAA
Delivery time：4-6 weeks
Overload capacity up to 150%/60 seconds, 200%/3 seconds, suitable for constant torque, variable torque, constant power and other loads
Support induction motor, permanent magnet synchronous motor, optional PG card for high-precision speed, torque and positioning control
Powerful low frequency output torque (0.5 Hz/200%, without PG vector control; 0 Hz/200%, PG vector control) helps heavy load equipment maintain stable operation at low speed and high torque
Built-in tension control special function
Support speed, torque and position control
Standard machine supports 599Hz, high-speed machine supports 2000Hz
Powerful system support
Built-in PLC (5k steps), supporting program programming, saving system construction cost
Built-in STO (SIL2/PL d) safety stop function to enhance safety and reliability
The whole series supports common DC bus
The standard configuration supports Modbus and CANopen communication (can be used as master or slave station), and provides multiple optional communication cards, including EtherNet/IP, Modbus TCP, EtherCAT, DeviceNet, PROFIBUS DP, PROFINET, and supports multiple applications and network communication requirements
Provide built-in filter model
Optional 24 V power card to reduce unexpected downtime
Flexible multiple expansion
Built-in 2 sets of 33 kHz high-speed pulse input terminals (MI6&7) and 1 set of output terminals (DFM)
Two sets of accessory card slots are built in, and PG card or I/O expansion card, communication card and 24 V power card can be installed at the same time
Expandable DI/DO, AI/AO and RY accessory cards
Excellent tension control
Built-in coil diameter calculation: coil diameter can be measured through linear velocity, material thickness and distance measuring instrument
It has two sets of PID parameters: it can be adjusted linearly to solve the tension control problem at startup and at different coil diameters and line speeds
Tension taper calculation: automatically adjust the tension value with the increase of the coil diameter during winding to avoid material wrinkling or deformation
Friction and inertia compensation during torque control: automatically compensate the mechanical loss and inertia such as friction on the retract/retract rolling bar to maintain constant tension
Automatic roll change: only external signal is needed to complete automatic material change without stopping
