DF3 two-way three-way solenoid valve
The DF3 two-way three-way solenoid valve has a closed cavity. There are through holes at different positions. Each hole leads to a different oil pipe. The middle of the cavity is a valve. On both sides are two electromagnets. Which side of the magnet coil is energized? The body will be attracted to which side, by controlling the movement of the valve body to block or leak different oil drain holes, and the oil inlet hole is normally open, the hydraulic oil will enter different oil drain pipes, and then through the oil The pressure pushes the piston of the cylinder, which in turn drives the piston rod, which moves the mechanical device. This controls the mechanical motion by controlling the current of the electromagnet.
DF3 two-way three-way solenoid valve working principle:
The DF3 two-way three-way solenoid valve has a closed cavity. There are through holes at different positions. Each hole leads to a different oil pipe. The middle of the cavity is a valve. On both sides are two electromagnets. Which side of the magnet coil is energized? The body will be attracted to which side, by controlling the movement of the valve body to block or leak different oil drain holes, and the oil inlet hole is normally open, the hydraulic oil will enter different oil drain pipes, and then through the oil The pressure pushes the piston of the cylinder, which in turn drives the piston rod, which moves the mechanical device. This controls the mechanical motion by controlling the current of the electromagnet.
Parameter range of DF3 two-position three-way solenoid valve:
Model specifications: DN0.5~DN500
:0, 0.1, 0.6, 1.0, 1.6, 2.5 ......................100MPa
Applicable medium: gas, water, oil, steam, refrigerant, corrosive fluid
Medium temperature: -200～+200°C
Medium viscosity: less than 50CSt (more than when needed)
Protection performance: IP65
Explosion-proof mark: ExdIICT5 explosion-proof type has F letter
Valve material: 304, 316,
Control mode: one input and two output (ZC2/31), two in and one out (ZC2/32), one in and one out (ZC2/3 normally closed. ZC2/3K normally open)
Power supply voltage: DC3 ~ 127V AC36 ~ 380V
Connection method: internal thread, external thread, flange
Leakage: zero
Remarks:
1 Dimensions and interface dimensions are faxed according to the product phone or drawing required.
2 Special requirements can be customized.
DF3 two-position three-way solenoid valve (pilot) 17
1. Overview: This valve is mainly used for pneumatic piping to control reciprocating cylinders. Made of copper. No ferrule, slippery seal, reliable action.
2. Installation and use: The solenoid valve should be installed horizontally. P is the air inlet. A is the working port. O is the exhaust port.
3. Specifications: 6.8.2.15.20mm. Size □ 63 × 95 × 98 mm
Contact email:sales006@rig123.com
Leon Lee
